i programmed analogue scaling block fc 105 for a (0 to 100 degrees).
When I run the programm. The cpu faults on SF.
The cpu is 314-6cg03-OAB0.
i am using TIA PORTAL V15.
Thanks
i programmed analogue scaling block fc 105 for a (0 to 100 degrees).
When I run the programm. The cpu faults on SF.
The cpu is 314-6cg03-OAB0.
i am using TIA PORTAL V15.
Thanks
Hi Royce,
Thanks for your comment!
My apologies, but your question is not quite clear to me yet. Would you be able to specify what the issue is you are currently having?
Hopefully, our technical support will be able to help you out a bit better that way.
Hi Manon.
I want to scale an analogue input that represents 0 to 100 degree Celsius temperature range.
I used the SCALE function to do this.
No errors showed ,when i programmed the scale function and downloaded it to the cpu314c-2Dp.
when i go to monitor and run the program.The CPU immediately faults and the red SF light comes on.
The diagnostics buffer reads:STOP caused by i/o access error (OB not loaded or nor possible).
I don't have any analogue signals connected to any channels.
Unsure how to proceed.
Thanks.