The previous lesson had us discussing Profinet-DP networks and the ET200. This lesson continues where we last left off with instruction on how to set up the network within the STEP7 environment.
We start by describing the many components we are going to have within our control system. We will walk you through creating a new project and adding the different modules, reminding you to check your order numbers to match up your equipment.
We will then show you how to add the Profinet-DP network to the control system configuration. Jump into this lesson and see how Profinet-DP configuration is done.
In this lesson we are going to continue discussing the Profinet-DP network software setup. In the previous lesson, we showed you how to add the Profinet-DP network to the control system configuration and that is where we will start in this lesson. We will talk about some different devices that ma...
This is part 3 of our lessons pertaining to Profinet-DP networks and how to set them up in the software.
In the previous lesson, we talked about what may be connected to the Profibus-DP network, wherein the catalog the device can be located, Profibus addresses, and how to work with addresses ...
In this video, you're going to learn how you can use the I/O on a remote station in the PLC program.
18 Comments